Description
Honeywell FS7-2173-2RP
Technical Specifications
- Detection Spectrum: Multi-spectrum infrared and visible sensor array
- Power Supply: 24VDC nominal, operating range 18VDC to 30VDC
- Rated Current Consumption: 55mA normal operation
- Relay Output: SPDT relay contact, 1A, 24VDC
- Flame Alarm Threshold: 13kW polypropylene pool fire
- Alert Pre-alarm Threshold: 3.9kW polypropylene pool fire
- Working Temperature: -20°C to +70°C
- Storage Temperature: -40°C to +85°C
- Enclosure Protection Grade: IP67, dust tight and waterproof to 1 meter
- Certification: FM, CE, ATEX, IECEx, UL
- Cable: Standard 20 feet pigtail cable
Functional Features It continuously executes built-in self-test of sensor and circuit. It distinguishes real flame from false interference sources by multi-spectral algorithm. It provides pre-alert and fire alarm two stage relay output. It stores up to six FirePics spectral snapshot data and 200 event records. It supports event data readout through dedicated PC interface software. It has status LED indicator, blinks once every 10 seconds under normal operation. It provides fault relay output for circuit failure or sensor damage. It supports stand-alone operation without host controller.
Application Scenarios Semiconductor manufacturing clean room wet bench fire detection Solvent processing hazardous area flame monitoring Pharmaceutical flammable solvent production room fire protection Chemical laboratory fume hood flame detection Industrial solvent storage cabinet fire alarm Clean room fire safety system detector replacement
Performance Parameters
- Response Time: Less than 15 seconds for alarm threshold fire
- Detection Field of View: 90° conical viewing angle
- Mean Time Between Failures: 620000 hours
- False Alarm Rejection Rate: High immunity to hot objects and visible light
- Relay Contact Life: 100000 operations at rated load
Material Composition Polycarbonate waterproof enclosure Multi-spectral photodiode sensor array Digital signal processing microprocessor Non-volatile flash memory chip Electromagnetic relay TVS surge protection components Transparent optical window with anti-scratch coating Sealing silicone rubber gasket
Structural Features Cylindrical leak-proof integrated housing structure. Front side is optical sensing window. Rear side sealed pigtail cable exits housing. Internal circuit and sensor are fully sealed inside IP67 enclosure. Built-in relay circuit board and memory chip are fixed inside housing. Mounting thread structure is reserved for bracket installation. Silicone gasket forms full waterproof seal between housing cover and main body.
Working Principle Multi-spectral photodiode array receives radiation signal from monitored area. The microprocessor samples spectral signal continuously and compares spectrum characteristic with flame fingerprint library. When signal matches flame spectrum and reaches alert threshold, pre-alert relay activates. When flame energy reaches alarm threshold, fire alarm relay activates. The detector records spectral snapshot data into flash memory when alarm triggers. If sensor or circuit fault occurs, fault relay changes state and LED indicates fault code.
Installation Requirements Install detector on dedicated mounting bracket and align optical window to monitored hazard area. Keep the optical window away from direct sunlight and reflective hot surface. Wire 24VDC power supply and relay output cable to fire alarm panel. Power on detector and wait 15 seconds for self-test completion. Verify normal blink status LED. Keep optical window clean and unobstructed. Set alarm logic in connected fire panel.
Usage Notes Do not cover or block the optical window. Clean optical window regularly to remove dust and solvent vapor deposit. Do not expose the detector to continuous direct high temperature flame. Do not apply solvent or corrosive cleaner to the optical window surface. Verify relay contact load current does not exceed 1A rating.
