Description
Traco Power TIS600-148-SIG
Technical Specifications Rated output power 600W; DC output 48V; Wide DC input voltage range; Galvanic isolation between input and output; Built-in overvoltage, overcurrent, overheat and short-circuit protection; Power good signal interface; Remote on/off control; Operating temperature -40°C to +85°C; Metal housing for heat dissipation.
Functional Features High efficiency DC-DC power conversion; Low output voltage ripple; Hardware protection shuts down output under abnormal conditions; Power good signal reports normal output state to host system; Remote enable/disable control function; Input reverse polarity protection; Parallel operation capability for power expansion; EMI suppression circuit reduces electromagnetic emission.
Application Scenarios Industrial control cabinet auxiliary power; Railway on-board power conversion; Telecommunication stationary power system; Renewable energy power conversion equipment; Heavy-duty industrial monitoring rack; Mobile industrial test equipment.
Performance Parameters Power conversion efficiency maintains high level at rated load; Output voltage ripple amplitude low; Protection trigger response speed is fast; Output voltage stability under input voltage variation; Thermal performance under full load continuous operation.
Material Composition Aluminum alloy metal housing; High frequency transformer; Power semiconductor switching devices; Aluminum electrolytic and ceramic capacitors; Current and voltage sampling circuits; Glass fiber PCB; Screw terminal blocks; Status signal connector.
Structural Features Enclosed metal casing; Screw terminals for high power input and output; Signal connector for power good and remote control; Internal heat sink bonded to power components; Mounting holes for fixed installation on chassis.
Working Principle DC input voltage passes input filter and reverse polarity protection circuit. High frequency switching circuit converts input DC into high frequency AC through transformer. The secondary side rectifies AC back to stable 48V DC output. Voltage and current sampling circuits continuously monitor output condition. Once overvoltage, overcurrent or overtemperature detected, control circuit cuts off power output and changes power good signal state. Remote on/off pin enables or disables converter operation.
Installation Requirements Mount module on flat metal surface for heat conduction; Tighten high-power terminal screws to specified torque; Input and output wiring cross-section matches rated current; Protective earth wire must connect to metal housing; Reserve airflow space around module.
Precautions for Use Wait for internal capacitor discharge after power off before opening housing; Do not operate continuously under output short-circuit state; Confirm total load power does not exceed 600W rating; Periodically clean dust on metal housing; Check terminal tightness under vibration environment.
