Description
Honeywell CC-IP0101
Technical Specifications Dual redundant RJ45 Ethernet ports; communication rate 10/100Mbps adaptive; comply with IEEE802.3 standard; support Honeywell FTE fault-tolerant Ethernet protocol; backplane 24VDC power supply; operating temperature 0℃~60℃; storage temperature -40℃~85℃; humidity 5%~95% non-condensing; support link state diagnosis; automatic link switching when single network cable fails.
Functional Features It realizes two-way redundant network access for C300 controller. When one network cable or switch fails, the communication is switched to another link without process interruption. It diagnoses physical link, port and network fault in real time and reports alarm to operation station. It transmits control data, alarm, trend and controller synchronization information on FTE network. It supports online hot swap.
Application Scenarios Redundant network access of core C300 controllers in petrochemical DCS system; FTE network interface of power plant unit control system; communication link of oil and gas station control system; network connection of batch control system in pharmaceutical factory; redundant network of offshore platform control cabinet.
Performance Parameters FTE switching delay is at millisecond level, and control data packet is not lost during single link fault. The communication delay of control message is stable and deterministic. The port has ESD surge protection. The link state detection cycle is fixed.
Material Composition FR4 flame retardant PCB with conformal coating. Gold-plated backplane connector. Industrial Ethernet PHY chip. RJ45 network port with lightning protection circuit. Front panel flame retardant PC material.
Structural Characteristics Single-slot vertical rack module of Series C controller rack. Front panel equipped with two network link indicator lights, power and operation indicator lights. Elastic locking buckles on both sides. Passive heat dissipation, no built-in fan. It is installed in the dedicated communication slot of C300 controller rack.
Working Principle CC-IP0101 is connected to two independent FTE switches through two network cables. The module receives the data packet sent by the controller through the backplane bus and forwards it to the FTE network. It receives the message from the network and transmits it to the C300 controller. FTE protocol judges the health status of two links, automatically uses the normal link to transmit data when one link fails, and sends network fault alarm.
Installation Requirements Install in the dedicated communication slot of C300 controller rack. Use Honeywell specified shielded FTE network cable. Two network ports must be connected to two independent FTE switches. Network cables and high-voltage power cables are separated. Cabinet grounding resistance ≤4Ω.
Usage Notes The firmware version of the module must be consistent with the Experion PKS system version. Do not use ordinary non-shielded network cables for FTE links. When replacing the module online, confirm that the controller redundant state is normal.
